Good used Bryant Carrier ECM motor HC23CE116 inducer assembly with a good wheel. Removed from a good working variable speed Bryant 90+ furnace. This is also used in the Carrier, Payne and others. I removed the motor cover and cleaned the dust from the cooling wheel and board. I inspected the board and found no bad solder joints, corrosion or water damage. The motor is in very good condition with good bearings. I opened the housing and inspected and cleaned the interior wheel. It is the newer black and gray style wheel and has no cracks developing, which is common with the older white or black/clear plastic ones. You can see the interior wheel thru the opening in the picture of the back. I inspected the housing inside and out and cleaned out all the gunk, including from the internal drain passageways. I even cleaned off all the old gasket material from the mating surface on the back so you will get a good seal. There are no cracks in the housing, all the plastic posts are intact and the seals are now new so it will not leak condensate. All the housing and motor screws are in place, none of them are missing or stripped out. I tested it on the bench when finished. It runs very well, gives the correct feedback signal and is ready to go. Please use the pictures to verify that the item is what you want. 320727-751 320727-752 320727-753 320727-754 320727-755 322550-702 324906-751 324906-752 324906-762 340793-762 320727751 320727752 320727753 320727754 320727755 322550702 324906751 324906752 324906762 340793762 5SME44JG2006D PHC23CE116. To ensure your safety, a professional technician should install this part and verify the proper operation of your equipment. I won’t waste your time. If anything is not right then just contact me with your solution.